Farmall & IHC Tractors Discussion Board |
Re: spliting a super-c
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on April 06, 2007 at 03:34:43 from (209.226.247.181):
In Reply to: spliting a super-c posted by Don's superc on April 05, 2007 at 20:09:57:
Don: Is the SC wide or narrow front. My brother has a device he uses on his narrow front. Two pieces of 6" chanel iron, bolted to cultivator mounts on each side, going towards floor just under clutch housing. Those clamp to a light trailer axle with wheels. This makes entire front end stable and he can roll it away by himself. He just puts a bottle jack under clutch housing. On wide front tractors I use a hardwood pallet with blocking, under each side on front axle and under back of engine. I use tiedown straps, tie it solid to pallet. Put wedges in front axle pivot. With a C-123 engine I built a wooden cradle so edges of block take weight. I use a bottle jack under clutch housing and a pallet jack to move the front end on the pallet. I have split tractors as large as 560 and put them back together using this system all by myself. I've also split a big articulated tractor at the pivot, removing the whole rear end with wheels, on a pallet.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|