Farmall & IHC Tractors Discussion Board|
Re: McCormick Deering Hammer Mill No. 10 C
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nebraska Cowman on March 25, 2007 at 06:58:34 from (184.108.40.206):
In Reply to: McCormick Deering Hammer Mill No. 10 C posted by LinemanFarmer on March 25, 2007 at 06:42:06:
The mill is only limited by the size of screen. If you have a small enough screen you can grind wheat but shelled or ear corn were the most common uses. Did you know the use hammermills to prepare junk cars for the smelter? Each hammer is about the size of a grown man.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters