Farmall & IHC Tractors Discussion Board |
Re: Rearend gaskets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas more info on December 01, 2001 at 17:31:54 from (129.37.117.112):
In Reply to: Rearend gaskets posted by cobo3 on November 30, 2001 at 19:35:28:
I just took everything off the transmission cover plate of my C because I am getting ready to split it just in front of the tranny to fix an oil leak that is coming out of the front of the transmission. I took the tool box and the seat off and I was amazed to find that the tapped bolt holes in the top plate to which the tool box is attached go all the way through into the transmission case! I was going to blow the holes out with air to clean them, and for some reason decided to probe with a small screw driver first. The tapped holes have no bottom!!! Wonder if all of them are like that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|