Farmall & IHC Tractors Discussion Board |
Re: John reguarding (M) pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on August 23, 2001 at 19:37:47 from (12.2.142.7):
In Reply to: John reguarding (M) pistons posted by Don on August 23, 2001 at 16:31:37:
I am not a M expert but I do know a good deal about Ford truck engines. There is a Ford 300. that is the cubic Inch displacement. It is an inline 6 cyclider with 6 in rods found primarily in half ton Ford trucks. This is one of Fords more popular desighnes. May people use the Rods of these motors to make a "stroker" that is putting this style of rod in a chevy V8. I have not heard of anyone useing Ford 300 pistons in a Farmall Block. I am not saying it impossable, But the bore size and Wrist pin location would have a big impact on the possability.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|