Farmall & IHC Tractors Discussion Board |
Re: PTO help for a C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on July 29, 2001 at 15:15:45 from (129.37.117.234):
In Reply to: PTO help for a C posted by Randy Red on July 28, 2001 at 23:05:26:
Looking at my parts manual for the C. The PTO and the belt pulley run from gears that mesh with two separate gears on the same shaft. If the pulley is running and the PTO is not, then it must be that something happened to the gear system that drives the PTO. Maybe the gear came loose from the shaft (it's Keyed to the shaft, or maybe the bearing is worn and let the shaft slide in or out so the gears don't mesh. IIt looks to me to fix anything in there, you are going to have to take the complete PTO housing off. The belt pulley housing has to come off first, but doesn't appear you will be able to see much regards the PTO when you get it off.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|