Posted by AJ. on October 20, 2012 at 07:21:23 from (220.127.116.11):
In Reply to: 1150 case posted by bill in colo on October 18, 2012 at 17:04:22:
Its a long time since I've seen an 1150 but seem to remember repairing the brake cylinders,as far as I can recall those cylinders were fairly standard Lockheed parts,7/8" if my memory is correct but I not 100% about the size,its easy to measure them,I used to get a repair kit from an auto parts shop going by the size rather than a part number, with the right size seals and a rub of a honing tool the machine would be back at work pronto,of course if the cylinder bore is too bad that would be no good but if the cylinders are ok they will be as good as new when you put new seals in,see what size you need and ask at your auto shop.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.