Posted by crazytractor on June 11, 2012 at 20:29:40 from (220.127.116.11):
Well i finially got the pony runing , well momentarily. I replaced the spark pulgs, and condenser, and polished the rotor and points. And started after a few tries. it started loud, but very strong and smooth. I got to turrining the enging, and after about two minutes it started back firing really loud and then shut off. the pony motor trans was leaking oil from a gasket so i will have to remake the gasket befor trying again. I know it can either be fuel or timing, but it was running really good before it shut off so i dnt think it was timming. It was so hot this saturday here in south texas that i didnt even check if it ran out of fuel. I check my spark plugs and they were dirt after small run. they were new. who knows why? what kind of oil does pont trans use incase it leaks out while changing gasket?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.