Case Tractors Discussion Board |
Re: Late model 930?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob/wis on June 26, 2006 at 11:29:44 from (69.179.7.45):
In Reply to: Late model 930? posted by 1030 brian on June 25, 2006 at 18:05:10:
We have a 1030 over at the other farm with them style of steps on it. All of the extra steel is diamond plate on it. I am just wondering if a company made aftermarket steps for these. They sure are nice for the old guys to get on and off them. For all the cabs I seen on the 30 series none used a base like this. We modified a set of steps off a old model E gleaner to our 930 this spring. My grand dad runs it and needed to get on it easier. It worked out great the steps run up along side the engine and has a nice platform at the top. Later Bob
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|