Posted by jon f mn on July 09, 2013 at 20:47:08 from (75.168.224.96):
Worked on the swather today and I think she's bout ready to cut oats. Had to replace the cast rings in the end of the reel that run on the 3 little idlers that offsets the 2 reel ends to work the teeth. I think the previous owner had some fail and ran it so long the castings were worn out. I got some from my local salvage yard today and got them in. I was surprised that everything came apart real easy, didn't even need to heat anything. If you need used or after market parts in central Mn. Gotvald Imp. Se. from Pierz Mn. is a good place. I also got a pickup attachment for the combine. I'll have to get that on and a patch in the bottom of the combine head where it's rusted and worn through. Looked at the oats today looks even better than last year, it's shoulder high and thick, but it went down a little in the wind today. Should be ready to cut in 3-4 weeks. Hope I get everything ready by then lol. Sorry no picks today.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.