Posted by oldproudvet on July 07, 2013 at 17:03:06 from (208.123.21.114):
Building on the post below, I had a conversation with a cow on Friday and one sprained ankle and twisted knee later I'm sitting the weekend out. I recently brought home a low houred late 1070 with a couple of control lever issues. In the power shift troubleshooting section it reads "shifter linkage bound/misadjusted cable bent, siezed or misadjusted" or something like that. I've paged thru the entire manual several times and can find NO mention or even pic to help with this. One page shows the PTO engagement lever, but from the wheel side, not the cab side. There must be something in there, is there not? When pages can be spent on valve seat angles that every 8th grade shop kid knows I'm puzzled by this or is it my own stupidity. Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.