Posted by Huntingdog on February 21, 2013 at 10:13:13 from (132.3.33.81):
Thanks for all the help. I have a couple of more questions for reassembly. The clutch design requires a clutch spring for every fiber plate, so the parts manual is incorrect.
After reassembly, I now have the clutch assembly back in the PTO cover, but how much pretensioning should be applied? How do you stop the clutch from slipping to adaquately pretension the clutch? It will be much more trouble to adjust the clutch after the PTO cover is on the tractor and I would like to get it as close as possible.
Right now, the clutch is adjusted as far as I can get hand tight, I despess the yoke to engage the clutch and apply pressure to the nut at the center of the clutch hub, holding the pto shaft still, but I can slip the clutch.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.