Posted by DKase on December 20, 2012 at 05:35:57 from (22.214.171.124):
In Reply to: 1370rod posted by t970 on December 19, 2012 at 21:19:35:
The piston does not move when you lift the arms. Next place to go is to pull the small cover on the side of the DOM valve that you say moves under the seat. There is a check valve, and 2 needle valves under there. DO NOT mess with the needle valves unless you have a service manual. One of them will need to be cleaned and reset, and the other is the adjustment for the control of the valve. DO NOT mess with this one!!!! I have not been into one for a couple years and do not remember which one is which. I do need to do my 970 before I blow snow again so one of these days I will have the info you need if someone else does not chime in.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.