Posted by j hikemper on November 24, 2012 at 15:55:03 from (50.102.88.37):
In Reply to: 3's posted by McKerrow630 on November 23, 2012 at 17:08:42:
hang in there , you can handle it ,, keep it together man , especially around those that luv ya,, hope you don't have to learn the hard way , like i did , you need sumthin to start working for you ,,prayer helps , a good secure job will definately help , as for the 188/630.more than likely head gasket..bars leak will make it go away for a decent sale ,,fyi . i fed my 430 /188 bars leak for a yr,and got by doing daily runner stuff before we finaly took it down ,only because the clutch was plumb shot ,had serveral bad valves ,and the dual steering cylandars were in a need for seals, and the 3 pt was drip in oil in the rear end .. when that fella came out of the shop 3 weeks later it was parade ready .that was 2007 .It STIL IS Parade ready
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.