Posted by jasonbickel on July 03, 2011 at 15:13:58 from (99.63.30.81):
In Reply to: Case 300 Clutch posted by jasonbickel on May 30, 2011 at 18:31:03:
Update, I have the tractor back together. Ended up having to reuse the piece of the throwout bearing that was worn down. It did separate from the throwout bearing easily using a chisel and then just press back together with the vise.
Got a new intake/exhaust gasket installed, adjusted valves, replaced valve cover gasket. Runs excellent now.
Replaced rear crank seal since I had it apart. Replaced hydraulic pump seals as it was obviously leaking, not sure if it fixed the leak though as I have a drip from the bottom of the bell housing.
Changed out rear axle seals, they were leaking pretty good. Replaced gear oil.
Would like to see if I can find a match to the one good tire I have, it is a BF Goodrich Silvertown 13.6 x 28. If anyone has one that is about as good as the one that I have i am interested.
No restoration for now, will just put back together and enjoy for a while!
This post was edited by jasonbickel at 15:15:29 07/03/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.