fIRST i am not expert on this. However you need to get to problem before you use 3 point again!!!!!!!!! I think you would be wise to remove pto an back cover an have knogeable person look inside to see that all is assembled corectly(PISTON PUSH ROD WITH ROUND ENDS ECT). Idont know if your park brake is working correctly but if someone put tractor in gear an did not have park RELEASEDit is possible to spring park pawl away from gear an it will give whining noise as it wears on top of big gear.Other points to check are-relief pressure did control stop three point when it should have-were outside lift arms correctly adjusted so as not to catch an not be able to raise. Obivoulsy something went very wrong to split casting an you need to find prooblem before you use tractor. I am sure others more familiar will help you.You can also go to cnh web site an see parts diagram Again do not run tractor till you find problem!!!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.