Allis Chalmers Discussion Board |
Re: head bolt torque spec
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on February 13, 2004 at 12:18:49 from (67.27.126.25):
In Reply to: head bolt torque spec posted by chad on February 13, 2004 at 05:44:43:
The tightening sequence on a head is from the center to the ends, alternating side to side. Just picture pushing the pressure away from the center, rather than locking it in somewhere. Torque specs vary with the size of the bolt- there are some 3/8?, some 1/2?. It's in the I&T manual, the manual is in the shop, and I'm not, so I won't trust my memory. It's gbs. And how you determine torque on the water manifold bolts??????????? I just substitute a combo wrench and compare it to the torqued ones.
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|