Posted by JMS/.MN on October 15, 2013 at 07:06:33 from (220.127.116.11):
In Reply to: Gleaner F heads posted by 4020 electrician on October 14, 2013 at 20:17:04:
If you"re talking about putting a flex head (not floating cutterbar like you have now), from an F3 on an F, it is a major upgrade, and spendy. You need the control module, $800 and NLA, plus the wiring harness that goes with it. I recently upgraded my M2 to an M3 system, found a used module and a harness from an N6.
IDK if the F would even have the basic harness that the module hooks in to. I doubt it, cuz you need the header height control option on the console. I think you"ll have to stick with the robot. Check with the folks at the combine talk show directory.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.