You don"t need to aline in an specific order. Just remember you never align them all in the same spot. This would cause blow by and oil cunsumption problems. What i do is offset the ring gap by 3rds or 180 degrees from one another. The oil ring scraper I place one at 10 o"clock above the wrist pin and the other at 4 o"clock below the wrist pin. There should also be instructions on which side of the ring faces up.
As for assembly lube i use whichever weight of oil I"m running in the crankcase for assembly. Set your rings in a bowl of oil before you place them on your pistons. Oil the gland that the rings are to be install in on the piston. oil the inside of your piston sleeves before placing your piston into them. oil the wrist pin and where the rod connects to the wrist pin. Need less to say just oil everything, no oil will cause damage when you start the engine. I even place a little oil on top of piston for more lubercation when starting. So with all this oil just make sure your deck is oil free and dry for your head gasket to seal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.