Posted by RON IN MN. on October 24, 2012 at 20:24:23 from (184.108.40.206):
In Reply to: D17 hand clutch posted by Mark1248 on October 21, 2012 at 08:56:13:
You can adjust the hand clutch,remove the cover on right side were oil lines go on into it. There are three places on this clutch were shims can be moved!! from frt.&rear of this unit to the center.you loosen two bolts ,remove a .015 ths.from frt.& rear & install in center ,tighten bolts , move on to other shims do same thing.should snap over frim.IF not let me know.RON
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.