I use an All-Crop 60 for beans, settings should be similar. I run the cylinder speed down around 600 rpm or less, clearance at 3/8", all 8 cylinder bars, both concaves. Vary the speed a bit to prevent cracking the beans, although I have never been docked for them. Watch your reel height to prevent shelling ahead of the cutter bar and get an even feed onto the canvas. Especially when dry beans are easy to shell so you don't need a lot of cylinder speed. If they are a bit weedy you will need need more speed and maybe take less than a full swath to keep from plugging. Little old Allis doesn't like the green stuff!! I run the air about 1/2 open, look at your fodder to see if you are getting all of the beans separated. Hydraulics on the header helps you keep down low, but you can't get as low as the new machines so don't even try. Accept some loss with a 60 year old machine. My beans are usually as clean or cleaner than anyone else's so good luck with it. Hope this helps you.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
