Posted by c_mayer on August 15, 2012 at 13:42:58 from (22.214.171.124):
In Reply to: engine exchange posted by Idahoho on August 05, 2012 at 11:32:58:
By the time you swap engines, you have almost the same amount of labor as just overhauling yours. You have to pull the camshaft to swap the front plate to make it fit into the tractor. Basically dismantle the whole engine less crank and pistons, and then re-assemble.
As a dealer, if you aren't sure of your ability to swap the engine, then get yours rebuilt. We have done this in the past for customers that refused to rebuild them, and it was basically the same cost....and you still have a used engine.
Feel free to give me a call if you'd like, I would be glad to help you anyway I can.
Chris Mayer Mayer Farm Equipment Jeffersoncille, OH 800-996-2937
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.