Posted by micheals on August 07, 2012 at 17:05:10 from (184.108.40.206):
I have a 190 on its last legs. I was going to move it out of the way so I could pour concrete. It started (with a good shot of ether) and run about 2 minute then died right in the driveway. I have replaced the fuel filter, cleaned the sediment bowl, blew out the fuel lines, and cleaned the screen on the inlet to the pump. I also inserted a fuel pump between the filter and the pump. It will start and run for 2 -5 seconds then dies. the longer I leave it sit, the longer it will run but not long enough to get it moved, plus it has a loader on it so pulling it is out of the question where it is sitting right now. Any suggestions?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.