Posted by Faster346 on May 02, 2011 at 20:02:49 from (72.241.201.224):
Well long story long, today I was out back spreading horse manure. I usually spread it in the neighbors field out back. Well, for the last few weeks, we've had non stop rain here in Michigan. The ground has never really got too soft out in the field, like it does up by the barn after a lot of rain. I have a certain path that I usually spread on, but today for whatever reason, I decided to run along the edge of the field that butts up to our land. All was going good, until the old M dropped like a rock about a foot into the ground. It was one of those moments you just knew you weren't going to walk out of easy. I tried backing back out onto the harder ground, but with the fully loaded manure spreader, it just spun tires and didn't move. My only option was foward. I tried to just drive through it, and made it about 15-20 feet, and it just dug itself down further. By this point, I was almost late for work, and the only tractor I had near me was my Super C, so I walked over, hopped onto it, and drove out into the field. I had little faith in the tiny little SC even budging the big ol M and spreader, but I hooked a chain to it anyways, got onto some solid ground, and gave her a yank while my Uncle drove the M, and it yanked it right out like it was nothing! Sure wish I had my camera on me at the time, but I had to just grab some "after" pictures instead. So I grabbed some shots of the ground, the little SC that could, and the big ol M and spreader. Notice how the ground up by the barn is...and they're calling for more rain all week...awesome!!
Nice solid ground..that all of the sudden turned to quick mud.
Front tires just dug and dug and dug.
Water almost instantly came up from the ground.
Tried backing out of it, front tires just knifed themselves deeper, probably the weight of the loader off the front.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
