Here is the bundle number you would need. It allows the system to dump pressure from one end of the cylinder to the other while maintaining the set pressure. This way you will not bend the opener arms. DO NOT TRY TO RUN WITHOUT IT!!! If you do and run over a hump or headland the openers on the high spot will try to carry the whole drill weight. I have seen bend arms and busted opener frames by not using the open center kit. When you use an open center tractor on a 750/1560/1590 drill it will not maintain the constant pressure on changing ground contours. You go over a hump the system will dump the oil if it goes over the set pressure. Then you will need to activate your SCVs after you are over the hump to recharge the system pressure. If your ground is fairly level it is not very hard to get used too. If you leave it engaged all of the time it will over heat the tractor hydraulics.
Open center hydraulic check valve: BN280593
This pilot-operated check valve traps oil to opener cylinders, maintaining preset position when tractor valve is neutralized.
Required if drill is to be connected to tractors with open center hydraulic system. May also be used with closed center hydraulic systems. If tractor valve is not neutralized on open center tractors, damage to tractor will result (heat buildup in the hydraulic system). Kit includes check valve, pilot line, and necessary hydraulic fitting for installation.
Bundle No. BN280593 Open center hydraulic check valve for single placement drills
I do not have the current price of the kit. The number is out of my drill setup manual.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
