Posted by bc on April 10, 2011 at 20:52:55 from (69.149.212.64):
Hi, I've got some leaking seals on my Case model 33 backhoe hydraulic cylinders. One stablizer and one swing cylinder has always leaked a little out the end. Now the boom cylinder is leading enough that sometimes it blows out the seal and leaks off when sitting. I can't chase that leak so its time to fix them. As far as I know, the piston packings hold and work just fine.
The boom cylinder has a 2 1/4" shaft and 5" cylinder. The stabilizer has a 1 3/4" shaft and a 4 5/8" cylinder. The pics should show where the seal is blown on the boom cylinder which I partially unscrewed. It has a flat rubber washer and 1/8" oring on the outside.
There is a pic of the stabilizer cylinder where I unscrewed the end collar. It has an 1/8" o-ring on the outside but no flat rubber washer like the boom cylinder. I can't see how to get at the seal and replace it. The pic of the stabilizer end collar shows a dime sized round place in the threads that apparently is filled with silicone.
Can anyone tell me how to get at the seals to replace them and how far do I need to tear them down to do it? Any parts online? Thanks for your help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.