Posted by James.6600 on April 06, 2011 at 09:05:27 from (174.47.108.232):
In Reply to: Re: Char Lynn posted by Ron Anderson on April 06, 2011 at 06:20:22:
As far as I can tell nothing is available but a seal kit for $30-$50 no hard parts available for the older models. I belive yours is the same as mine so just for the info those Eaton pumps I have seen on tractors are bushed with no bearings and hard parts are not available for them either. Ford used the same pumps until 1964 on all their power steering vehicles, the 1964-1/2 and 1965 mustang had the same short snout pump with the resavoir mounted on top that can be removed and the port block mounted. Also the dump trucks large body cars and a lot of forklifts used these pumps. The snout is 1/4 to 3/8 inch longer and these pumps have bearing instead of bushings and they are available new. I have seen these pumps for $150-$300 but I have seen them on ebay new really cheap like $10 if they dont know the exact aplication. Thanks for the reply James
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
