Posted by glennster on March 10, 2011 at 06:05:35 from (75.57.126.3):
In Reply to: Is this safe? posted by GeneMO on March 09, 2011 at 15:44:37:
gene , if you are going to use the loader, i agree with the shut off valve. i bought and old ford 1 ton van with a 28 ft stick on it for up in the air work. i prefer to use an electric chainsaw on a pole run off a generator. a lot less fooling around when you are airborn. farm and fleet ect sells a remington 10 inch electric chainsaw bolted to a fiberglass pole for about 90 dollars. works good, and pretty cheap. you can also hit your local rental place and see if they have a personnell lift. i rented one for the weekend one time to work on a corn crib. basically a boom lift with a bucket on a single axle trailer. has a lawnmower engine driving a hydraulic pump. 4 out riggers to stabilize. has about a 40 ft stick on it. about 200 for the weekend. if you do use a bucket and boom, take a big diameter rope with you in the bucket, long enough to reach the ground. if something fails, its a lot easier to slide down the rope than shinny down the boom. dont ask me how i know!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.