Posted by frdmnn on February 23, 2011 at 17:51:07 from (173.88.124.133):
In Reply to: O/T Ford truck posted by .RIVIR. on February 23, 2011 at 16:19:16:
it will bolt right up to the tranny, same bolt pattern. 460 motor mounts are a different bolt pattern on the block,but you can use 460 car motor mounts if you don't have 460 truck mounts,you just bolt the car mounts on the block and then lower the engine in place and bolt up to tranny, and let the weight of the engine down on mounts, from under truck mark holes in the frame hangers, raise engine enough to get the motor mounts out and drill holes clear thru the mount, now install the proper length bolt, put mount back on the block, let the motor down, install nuts on the motor mounts and your done.the distributors are interchangeable also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
