Posted by LOU from Wi. on February 14, 2011 at 21:23:15 from (174.124.110.80):
We have posted pictures of our 706 back half in hopes that there will be somebody on here that has the same type rear end assy that we have so we can add a 3 point.We've searched the internet looking for a 3 pt unit or at least photographs (closeup) so we can determine how difficult it would be for us to manufacture an exact duplicate of the 3 point. For us to duplicate one is within our capabilities to do so.What we need is plans(pictures,with measurements) or to save ourself trouble of manufacturing one would be to have a manufacturer that can produce a 3 point for a 706.Nowhere on the internet(that we found)lists manufacturers for 3 points for the 706.Where do we go from here? We're not quitters and won't give up.We haven't on any project thru the towel in on any project we under taken.Not about to start.Just need some help Regards, LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
