Posted by snoop-nc on January 04, 2011 at 12:08:07 from (67.213.46.75):
In Reply to: Designing a work shop posted by redFarmallboy on January 04, 2011 at 11:40:04:
redFarmallboy: count the number of "radiator caps" you want under roof and build at least two more parking bays than you have "radiator caps"...this will put off for a year or so you having to expand your facilities to accomadate your newly acquired tractors. Width of parking bays should be no less than 12ft. My enclosed shop is 28ft. wide and 24 ft. deep with 4 12ft. X 24ft. parking bays under the open front shed...Farmall A, 4000 Ford, 4610 Ford, 15hp Garden tractor, F350 Flat bed dump...plus 3 or 4 pieces of equipment that must be shedded and I'm outta room already!! I do wish my enclosed shop was wider/deeper...???
Have fun putting together your "plan" and then "doing" it!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.