Posted by 135 Fan on January 03, 2011 at 13:53:23 from (68.149.56.30):
In Reply to: O/T Cataract surgery posted by 37 Chief on January 03, 2011 at 07:29:31:
Fantastic procedure! Just make absolutely sure that you have a very experienced eye specialist perform the surgery. My dad had his eyes done in the early 90's when it was a relatively new procedure with very few specialists that were performing it. My dads optometrist recommended my dad pay the extra money and go to Calgary(3 hours away) to the Gimbel Eye Center(a pioneer in cataract surgery). The procedure was normally $4000/eye back then but Alberta healthcare paid half. My dad said it was like getting a new set of eyes! They also gave him a video of the whole procedure. Only takes about a minute. The reason my dads optometrist recommended going to Gimble(private clinic) over having it done in the hospital at an even lower cost was because another client of the optometrists wanted to save money and didn't mind waiting to have it done in the hospital. Bad mistake on the patients part. He was left with scratched corneas and other problems from the surgery. The optometrist couldn't give the same of the Dr. who botched the surgery because of legal reasons. There has been a lot of debate over private clinics in Alberta. The Gimble Eye Center was one of the first private specialty clinics. They had patients from all over the world with a better than 99% success rate. My dad didn't regret going there at all. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
