Posted by Cockshutt Mike on December 17, 2010 at 07:34:51 from (67.142.168.20):
HOUSTON — A jewelry store owner shot and killed three armed men who tried to rob his business, police said.
Two men were in an east Houston jewelry store Thursday afternoon pretending to be customers when a third man burst into the store and stated, "This is a robbery," Houston police spokesman Kese Smith said.
All three men then pulled out pistols, tied up the store owner's wife and took her to a back room, Smith said.
As they were trying to tie up the store owner, the 52-year-old took out a handgun from his waistband and fatally shot one of the suspects, Smith said. The store owner then grabbed a shotgun and shot and killed the two other suspects in the ensuring gunbattle, Smith said.
The Houston Chronicle identified the store owner and his wife as Ramon and Eva Castillo, 48. The newspaper said Castillo was in critical but stable condition at hospital after suffering gunshot wounds to his left shoulder, left abdomen and legs.
According to the Chronicle, Castillo apparently initially didn't realize he'd been shot until after he untied his wife.
The woman was unharmed, police said.
'Bullet fragments all over the place' Houston Police homicide investigator M.F. "Fil" Waters told the newspaper it was difficult to estimate how many shots had been fired during the two- or three-minute span.
"We've got bullet fragments all over the place, casings all over the place, shotgun slugs all over the place, so it's really hard to determine at this point how many rounds were actually fired — but quite a few," Waters added.
"It is a pretty incredible story. The man was clearly defending his business, clearly defending his wife," Waters told the newspaper. "It's amazing with all the bullets flying around in there that she wasn't hit."
Police are looking for a fourth suspect who may have been the getaway driver and was last seen driving a brown or gold colored vehicle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
