Posted by Hobo,NC on December 04, 2010 at 05:09:03 from (98.16.11.156):
In Reply to: O.T. Chevy vibration posted by larry@stinescorner on December 03, 2010 at 20:48:30:
Quoting Removed, click Modern View to see
Its not your tires,,, some dunno and are just run'n up their post count... Tires Don't Buzz
The tip is it happens under acceleration,,, one thing that would help is if you can make the noise happen while sit'n still in gear brakes applied with lite throttle,,, then I would be look'n for something hitting/loose/broke because of engine torque..
3 strange thinks I have found on a chebby truck
1) oil dip stick tube mount to head broke
2) right side of trans heat shield that shields the trans from the cat converter broke,,, its bolted to the trans with 2 bolts
3) cross member mount bolts loose,,, they would appear to B tight,,, you got to put a pull handle on'em and honker down on'em,, the tip off is rust around the bolts...
lots of things it could B,,, good luck no one likes hut'n down noises... You either a hero are a zero.... It sure nuff helps when you can put a good word to the noise... I had a Chrysler that sounded like you were removing a plate from the kitchen cabinet when you hit a bump,,, the noise was rite under my nose but liked to never found it... It took me days to pattern the noise and eliminate all the other noises that could play into the complaint,,, once I could put a word to the noise it helped to narrow down what I was look'n for... A car with 68K on the clock drove by a old lady,,, a 2001 Chrysler that mother nature had taken her toll on,,, it had a bunch of biodegradable parts....,,, a million parts retained with push pins,,, Ok that's my rant for the day..
If it were a Chrysler I could almost guarantee the cat converter was broke internally,,, never seen this on a chebby tho...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.