Posted by UpNorthWi on September 25, 2010 at 19:59:59 from (207.200.116.74):
Hello, I need advice on a grader blade for my tractor. I have a Mahindra 3015 compact 30HP 4wheel drive with loader and industrial tires, no weights or ballast. A 5' blade came with it, but when angled will not clear the tire width which is around 60" or so. I was looking at a 6' but was wondering if I could handle a 7', and what weight range should I be looking? It seems cheaper blades are around 200# and heavy duty close to 400#.
Since it's main use will be for snow, I've noticed most blades seem to have a flat mold board. Don't I need a curved or round one so snow rolls off and away from the blade?
Finally, I'm lost in brand names, weights, sizes and cost. Anyone have a good, fairly reasonable recommendation for the Southeastern Indiana area?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
