Posted by Paul N Texas on September 08, 2010 at 16:27:16 from (69.5.209.149):
In Reply to: CB on tractor posted by 550Doug on September 08, 2010 at 06:58:45:
As others have said, if the current radio has a connector for an external antenna, you can use a good antenna, and make good use of what you have. I would suggest buying a better radio like the Cobra or Uniden suggested. The reasons for that are: It will have the antenna connector. It will also have a jack for an external speaker/headphones. It will also have better circuits for noise rejection (noise blanker, noise limiter). Depending on where you have to locate the antenna will have an effect on your range, and the amount of noise from the engine/ignition. It needs to be mounted as high as possible, like on the top of a cab (which you said it was an open tractor), or a metal cover (roof). You can set it on the fender if they are flat on top, and keep it away from some of the noise, but range will drop (it's low). The reason for the external speaker/headphone jack is two-fold... You can run an external speaker, and get quite a bit of audio from it. You can also use a decent earphone (notice, ONE earphone), and still be able to hear what is going on around you. The noise cancelling mike is a good idea too, as it will cut out much of the surrounding noise from the engine etc. You may find a weatherproof mounting case you can safely mount the radio in (like we used to put the AM/FM radios in), and not have to worry about it getting wet. Mount it in a place where it will not interfere with the operation of the tractor, such as not getting the mike cord tangled in the steering wheel etc. They can offer a bit of help and entertainment out there. I am a Ham Radio Operator, and if I was to be working in a field much, I'd have a rig of some sort with me. When I was younger, and working in fields, we just didn't have gear that was portable enough to have out there, even in a truck. These days, there is no reason not to be able to enjoy the hobbies etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
