Posted by Dutchman on August 20, 2010 at 16:36:14 from (69.66.112.75):
I do Soda Blasting and needed a Air Compressor to handle the CFM and PSI .. that I needed ... Anyway a friend had this Schramm compressor and now it's mine .. the magneto was rebuilt , the gas tank clean and lined , and carburetor clean ..
My problem is .. it will only run with the CHOKE 1/2 out or more .. I e-mail the Schramm and found out that they made compressor's from 1900 to 1980 ... no parts or manuals ... Does anyone out there have any ideas what or where I can some advice ?? the compressor only has 215 hours on it .. been sitting most it's life .. it puts out 100 psi or 500 psi ... Would like to get it running better and get the 100 psi up to 150 psi .. if possible .. Just need to know how ... it is a 6 cyl. with the 1st 3 cyl's as engine and last 3 as compressor ... have no idea what make of engine ..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
