Posted by Omac on July 08, 2010 at 11:12:07 from (12.52.17.66):
I have a free driveshaft that has a 1 3/8+ACY-quot+ADs- smooth end with a 1/2+ACY-quot+ADs- diameter hole for a shear pin. The other splined end has a quick release for attaching it to the pto. I can use my brothers rotary cutter, but it has a splined male end at the gearbox with a 1/4+ACY-quot+ADs- hole through it. One option is to get a slip clutch with a smooth end for the shear bolt and a female splined end for connecting to the rotary cutter. Another option would be to change the yoke to a splined end, but then there wouldn+ACY-quot+ADs-t be any weak point to +ACY-quot+ADs-shear+ACY-quot+ADs- or +ACY-quot+ADs-slip+ACY-quot+ADs-. +ACY-lt+ADs-p+ACY-gt+ADs-Is there an adaptor that has the following: One smooth 1 3/8+ACY-quot+ADs- diameter male end with the 1/2+ACY-quot+ADs- diameter hold for a shear pin and one female splined end with a quick attach button? This seems like it would be ideal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
