Posted by JMS/.MN on June 29, 2010 at 08:58:08 from (209.237.107.155):
In Reply to: Haybine turning posted by ryanwheelock on June 29, 2010 at 06:00:20:
Turning left at each turn is a big waste f time and leaves a poor windrow, unless you stop long enough for the machine to clear. Do like the others said- when the machine pushes back to make the turn, it will push the cut hay back as well- should not clog. Easier to follow that windrow with a baler than what you end up with by turning left.I always preferred cutting in lands, rather than around the field, but that was because I chopped haylage, and would switch wagons at the road end of the field. All fields were quarter or half mile long, and if necessary would split a windrow in the middle to end up full on the end- next load I"d pick up the rest of the split ie- 3 windrows on each load.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
