Posted by Goose on June 19, 2010 at 10:39:32 from (67.63.68.13):
In Reply to: Bondo posted by Two Banger on June 19, 2010 at 09:34:39:
For openers, if you need to use Bondo over 1/8" thick, you haven't done enough basic work and you're headed in the wrong direction.
I usually use a DA sander with a 40 grit disc for initial smoothing, an air file with a 40 grit strip for leveling, and a plain old hand file with an 80 grit strip for final work.
It's all a matter of having the right tools, knowing how to use them, and not being afraid of dispensing with a copious amount of elbow grease.
Speaking of Bondo, we have a local body shop owner nicknamed "Bondo Bob" because of the amount of Bondo he uses. I once had a shop where his front parking lot was visible from my office. I was BS'ing with a customer one day when an 18 wheeler pulled into Bob's parking lot. My customer commented, "Looks like Bob's getting another load of Bondo".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
