Posted by J Heitkemper on June 13, 2010 at 07:39:35 from (98.115.119.135):
In Reply to: ATF did it again posted by old on June 12, 2010 at 10:43:47:
Guys , we put atf in a stuck 730case gasser We resurrected last fall ,and got her running ,, What DO YOU THINK WE SHOULD DO ?Trouble is the rocker arm assembly is getting just a few drops of oil thru ,, has very good oil pressure , and comes up to rocker assembly good.. got a qt. of atf in the oil ,, and have not done any work at all with the gal , because i want it to be oiling better ... I suspect rust particles in the rocker area , but am unable to clear during cleaning ... been resisting the urge to use SEA FOAM ,, ruined a gunky chevy Celebrity when it cleanrd the engine and spun a rod bearing , I THINK because of loose gunky carbon , pumped thru the crank jouranals ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.