The 5 ft woods mower off my IH C used the shaft on the tractor that a flat pulley would fit on. This shaft was on the right side of the tractor. My mower shaft turned clockwise when looking down on the shaft. It was a right hand discharge mower. Changing the blades will be a real bad idea. Woods blades attach with a bolt that is self tightning. You hit something with the blades the bolts tightes up. Try to rotate the shaft the other direction, hit something and the blades fall off. I took my 5 ft mower off and replaced it with a 6 ft belly mower off an IH H. I had to use an 18 inch pulley attached directly to the pto. The mower shafts turn CCW, and is a left hand discharge. I think your IH A has a small shaft on the left side of tractor, and you mower shaft will rotate CCW. Look at your blades and see which way they need to turn to get the job done. My advice to anyone buying a woods mower is to first call Woods at 815-732-2141 and ask to talk to a service tech. I found them to be were very helpful. Not all woods mower deck will work on your tractor. I have listed on this sight's photo adds my 5 ft mower, but I think it will be the wrong rotation for your tractor. LOL George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
