|
Tractor Talk Discussion Board |
Re: brush hog heighths
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on June 18, 2001 at 19:08:52 from (65.81.120.250):
In Reply to: brush hog heighths posted by Joe Torok on June 18, 2001 at 17:59:44:
Are you trying to hold its height with the 3pt hitch? I'm certainly no expert on bush hogs but the ones I've seen have a tail wheel to set the height with. There should be a way to raise and lower the tail wheel to set the height of the rear of the hog. On level ground adjust the top link so the bush hog is slightly maybe an inch lower in the front when the hydraulics are all the way down and the tail wheel is on the ground. Leave the hydraulics all the way down when mowing.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1941 John Deere B Row Crop - by Anthony West (UK). The 1960's promise of white hot technology, to relieve us of the drudgery of everyday work and to replace it with increased leisure time has not materialised just yet....if anything most people are caught up in an ever increasing rat race, wishing that there was at least 36hours in a day!!!. The need for people to escape for periods of relaxation in an increasingly complex and pressured environment takes us into the realm of hobbies. For some it's scaling high mountains for others it's putting p
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|