Posted by Jerry/MT on May 11, 2010 at 14:50:49 from (206.183.116.129):
In Reply to: Electric fence voltage posted by CB in central NY on May 11, 2010 at 06:55:16:
The 8400V rating is most likely a no load voltage at the terminal of the charger. The impedance of the wire will reduce delivered voltage.
I have a Horizont wide impedance solar charger from Premeir1 and it runs a 3/4 mile single high tensile wire fence at 5000 volts. I have a Gallagher S20(Ithink)and it"s about the same. 10,000 feet is nearly two miles so it doesn"t surprise me that you are down to 3500 volts. It should still turn a calf if the soil is damp, however. In dry ground, you may need to run a separate ground wire about 4 inches below the hot wire because you can"t use the dry ground for the return circuit in some cases.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
