|
Tractor Talk Discussion Board |
Re: Re: Re: Re: coupler -hydraulics etc.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD70Jim on May 31, 2001 at 07:17:29 from (64.197.39.96):
In Reply to: Re: Re: Re: coupler -hydraulics etc. posted by paul on May 30, 2001 at 23:32:26:
If you have an early 1209, it has two single acting hydraulic lift cylinders in the back to raise it up. Later ones had only one lift cylinder and where the second cylinder used to be located there is a simple sleeve and shaft arrangement. There is provision on this piece for a locking pin. The pin goes in a hole and prevents the sleeve from retracting on the inner shaft, thus "locking" the moco in the 'up' position. I do not know if earlier models also had a lock out on the outboard lift cylinder or not, mine is a late model.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
