|
Tractor Talk Discussion Board |
Re: Mitsubishi 4WD to 2WD Conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by twopop on May 27, 2001 at 15:16:20 from (65.197.93.91):
In Reply to: Mitsubishi 4WD to 2WD Conversion posted by Don Denier on May 27, 2001 at 12:39:06:
you havent stated exactly what the problem is,so i cant definately say,however if the problem is the ring and pinion then all you would have to do is take out the axle shafts,and the drive shaft if its in the planitary in the hubs then take out the axle shafts and the planitary gears,i cant think of any safety problems that you would incur
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
