Tractor Talk Discussion Board |
Sandblasting a tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Eric Perry on May 18, 2001 at 20:03:58 from (64.12.104.21):
I am starting my first tractor resetoration of a Oliver Hart-Parr 70 and I would like to sandblast it before I paint it. My plan is to remove all sheet metal, engine, gas tank and clutch and brake linkage then try to tape up around any shafts then sandblast it. I would then remove the brake covers and transmision cover and clean them out and do any nessesary repairs including installing new seals. My concern is after I sandblast it, should I prime it first to prevent rust from forming on the clean metal? I saw an ad from a company called "The Shop" in some magazines and they have a product called Rust Preventer, would this work as a coating after sandblasting and give me time to work on it before I prime it? My father has restored several tractors and he repairs them first then sandblasts them but it seems that the sand gets into everything and could cause problems. I notice that when I use our Farmall H,that had this done,every time I step on the brakes it makes a nasty grinding noise. I am open to any suggestions anyone may have. Thanks, Eric.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|