Posted by Gene Davis (Ga.) on March 25, 2010 at 17:34:20 from (98.67.54.17):
In Reply to: Paul Bunyon's saw posted by Gary fom Va on March 25, 2010 at 15:51:17:
All the old 2 man saws used bars like that and some had bows. They used a chain with aboiut a 3/4 inch pitch instead of the small .375 of the lightweight direct drive saws of today. All 2 man saws had handles on the outside bar/bow end. The guy on the outside handle did most of the work, he had to hold the saw in the cut, pump the oiler and still be ready to run when tree cut loose. The guy on the engine just held the engine handle bars and worked the throttle. This was how it was done with the old McCulloch 99 series 2 man saw.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
