Posted by greenbeanman in Kansas on March 03, 2010 at 16:21:03 from (99.38.200.87):
In Reply to: Duals vs no duals posted by Dave from MN on March 03, 2010 at 06:17:58:
In the 1970s I kept reading about radial tires which were something new for tractors.
My 1070 Case had fluid ballast and wheel weights too but had fairly well worn tires when I purchased it.
I inquired about buying a set of radials and the local tire shop had never sold any nor carried them. However they did make me a deal---I could buy them at their cost if I would go pick them up 100 miles away at the distributor, and if I would allow them to refer others to me as others considered purchasing them. Of course I did have to pay for mounting, but I went for the deal.
The very first thing I noticed when driving the tractor home was the sound in the cab. Very little. The ride was better too.
When pulling an 18 foot disc I gained a full one acre per hour using the same gearing and engine speed as before.
I haven't farmed for years so don't know if everyone has them as duals or if they are even available, but I for one would opt for radials any day over duals. With our soils and crops compaction was not a big issue as it might be for others.
To me the extra purchase cost was well worth the 1 acre per hour advantage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.