Posted by Leyland-270 on March 03, 2010 at 07:12:24 from (75.221.21.95):
In Reply to: Duals vs no duals posted by Dave from MN on March 03, 2010 at 06:17:58:
If you want to read up on it there are some tech manuals that will explain it perfectly. I could not find a web site at this time but I am sure there is one out there.
I have a John Deere and a Ford manual put out by the dealerships. Other than the brand of tractors in the photos the info matches. According to the books duals will cut compaction is half. As for traction, well there is where it gets confusing. It is based completely upon soil types and conditions. Believe it or not duals can double your traction or may decrease traction by 20%. I have tried to figure out a general rule of thumb but the best I could do is to tell you that duals may not help on sod bound soil depending upon implement. In most other cases there is no loss of traction. You will notice the most gain in loose fine (sandy) type soils. Weighting is just as important. If you are experiencing power hop, or loss of traction before power loss you are not weighted properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
