|
Tractor Talk Discussion Board |
Re: Re: Concrete floor for pole barn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red randy on April 11, 2001 at 14:46:43 from (216.120.139.207):
In Reply to: Re: Concrete floor for pole barn posted by Dean on April 11, 2001 at 10:01:03:
I have been in the concrete bussines for 15 years in michigan and have same conditions as you. I suggest you install a 5" slab and use fiber mesh. If you use rebar or mesh you can not drive trucks in for placement. I suggest using 5 1/2 sack air entrained concrete mix and 1" stone. The biggest cause of concrete failure is a insufficent compacted subgrade. you can use a mechical compacter or your tractor. If you pour in sections you need to either dowel the slab together or use a keyway joint. My barn is just this same way and I run larger equipment than you are going to.Any questions just ask.
Red Randy
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
